Oct 21,2022

　　Today, HG HPMC capsules manufacturers will share with you the daily maintenance work of the capsule equipment machine, hoping to help you.

　　capsule equipment machine integrates machine, electricity, and gas, adopts a microcomputer programmable controller, touch panel operation, frequency conversion speed regulation, and is equipped with an electronic automatic counting device, which can automatically complete the capsule positioning, separation, filling, locking and other actions. , reduce labor intensity, improve production efficiency, and meet the requirements of pharmaceutical hygiene. This machine is sensitive in action, accurate in the filling dose and convenient in operation and suitable for filling various domestic or imported capsules. It is economical and practical equipment for filling capsule medicines in the pharmaceutical industry.

　　1. Check the record of handover to work every day for troubleshooting.

　　1.1 Troubleshooting must be carried out in the shutdown state, manually according to the operating procedures of the capsule equipment machine, after confirming the fault condition, ask the mechanic to repair it.

　　1.2 If the electrical control system fails, first cut off the power supply and ask an electrician to check.

　　1.3 The filters of vacuum pumps and dust collectors should be cleaned regularly. If the vacuum degree is found to be insufficient, the vacuum pipes should be carefully checked and the blocked dirt should be cleaned up.

　　1.4 Open the protective stainless steel guard plate of the machine, and check whether the locking round pins of each transmission gear and cam are loose.

　　2. Clean the oil stains on the following parts once a week, and add the appropriate amount of lubricating oil.

　　2.1 Cam roller working face, bearing.

　　2.2 Rolling bearings and gears on the connecting rod.

　　2.3 Slide the guide rod.

　　3. Check the tightness of the transmission belt once a week, adjust it properly, remove oil stains, and apply grease.

　　4. Check the oil quantity of the main drive reducer of the vacuum pump every month, add oil if necessary, and replace the lubricating oil every six months.

　　5. After the equipment has been working for a long time, it is necessary to regularly clean the parts that are in direct contact with the medicine, such as the powder funnel, dose disc, sealing ring, powder scraper, module rod, etc. When the medicine needs to be replaced or the machine stops for a long time, it should For cleaning, the parts on the table are not allowed to be cleaned with solvents such as gasoline, kerosene, acetone, etc., and can be wiped with a sponge moistened with ethanol.

　　6. After the overhaul and maintenance of the capsule equipment machine, fill in the equipment modification, overhaul, and maintenance records.