Dec 23,2022

　　Today, the editor of the capsule filling machine will share with you the operation steps of the automatic empty hard capsules filling machine, hoping to help you.

　　The transmission chain of the automatic empty hard capsules filling machine should be checked once a week, and an appropriate amount of grease should be added, and it must be re-tightened if necessary. When the chain is too loose and needs to be re-tightened, the tensioning wheel should be moved for adjustment, but the chain cannot be opened or separated from the sprocket, so as not to disrupt the movement sequence of the entire mechanism and prevent the mechanism movement interference.

　　1. Press the green button on the "power switch" to turn on the power.

　　2. Slowly adjust the "vibration intensity adjustment knob" and turn it clockwise. At this time, the finishing tray integrated with the "vibration bracket" starts to vibrate. Touch the finishing tray with your hands and adjust to a certain vibration intensity by feeling.

　　3. Put the powder-filled capsule shells into the "powder-filled capsule shell finishing tray", and put about 300 capsules each time. Put the capsule caps into the "capsule cap finishing tray", about 300 capsules each time. The finishing tray is made of a plexiglass plate, and there are many round holes in the shape of upper, lower, and lower funnels drilled into it. The diameter of the round holes corresponds to the diameter of the capsule number.

　　4. In about 30 seconds, the powder-filled capsule shell and capsule cap will fall into the round hole with the opening facing up. In case of individual openings facing downwards, the capsule cap can be used to gently press down on the sleeve to pull it out.

　　5. Hold the connecting plate of the powder-filled capsule shell horizontally (the one drawn at the end of the figure, which has been prepared randomly, and there is a round hole in the connecting plate), and gently push in the lower part of the sorting tray, and the powder-filled capsule shell in the sorting tray will be released. It will fall into the round hole of the connecting plate, and then take out the connecting plate. In the same way, take out the capsule cap with the capsule cap adapter plate.

　　6. You can prepare a square medicine powder plate with a bottom area of 500×500mm2 and a height of about 10mm on four sides, which is filled with medicine powder, and put the powder-filled capsule shell joint plate on the square medicine powder plate. Then cover the random plexiglass frame on the connecting plate of the powder-filled capsule, use a small bucket to shovel the powder into the frame, scrape the edge of the frame to fill the powder, and scrape off the excess powder.

　　7. Use the random capsule cap set plate (shown at the end of the picture, there are round holes on the set plate), and put it on the capsule cap connecting plate, with alignment holes, which are easy to place. Turn over the connecting plate of the capsule cap so that the opening of the capsule faces downwards, and put it on the connecting plate of the shell of the powder-filled capsule that has been filled with medicine powder. There are also alignment holes, which are easy to fit.

　　8. Put the nested capsule plate into the cavity under the "capsule cap forming plate", and pull down the "pressure lever" by hand to put it in place. Don't be careful with excessive force, because the capsule filling machine has a positioning mechanism Control the drop height. Take out the sleeved capsule plate and pour out the capsules.