Feb 21,2023

　　The bottom of the metering tray of the automatic capsule filling machine is embedded with a sealing device to improve the leakage of powder, reduce the wear of the parts of the automatic capsule filling machine, and make it easier to clean. Around the dosing plate, there is a baffle that very efficiently passes the powder expelled from the lower surface of the dosing plate through the duct. Reclaim and recycle while reducing dust on work surfaces.

　　Automatic capsule filling machine avoids cross-contamination and saves energy: redesigns the capsule finished product discharge mechanism, eliminates the air compressor, thereby reducing the overall size and noise of the whole machine, avoids cross-contamination and motion failure caused by air pressure discharge, and achieves remarkable energy saving effect.

　　The automatic capsule filling machine can easily adjust the gap of the dosage plate. Just by adjusting the angle of the gear mandrel, the transmission gear can be driven and the five support bolts can be raised or lowered at the same time. In view of the different characteristics of Chinese and Western medicine, the operating pressure required for filling is relatively high. Largely, increase the size of the cam, use nitrogen flower treatment on the surface of the cam, increase the surface hardness, and ensure the equipment life and operation reliability of the automatic capsule filling machine.

　　Precautions for automatic capsule filling machine:

　　1. (Automatic Capsule Filling Machine) This equipment is a vibrating machine. The screws of each component should be checked frequently for tightness. If it is loose, it should be tightened in time to prevent failure and damage.

　　2. The plexiglass parts (worktable, medicine board) should avoid direct sunlight and be close to high temperatures, and do not place heavy objects. The medicine board must be placed vertically or flat to avoid deformation and damage.

　　3. The electrical enclosure and body must be grounded to ensure safety, and the power supply must be cut off after the work is completed.

　　4. After the daily work is completed, the residual medicine in the automatic capsule filling machine and the mold hole should be cleaned to keep the whole machine clean and hygienic, and avoid washing the main machine with water. If you need to clean the mold on the machine, you can loosen the screws and remove it for easy installation.

　　The bottom of the metering tray of the automatic empty capsule filling machine is embedded with a sealing device to improve powder leakage, reduce wear and tear on machine parts, and facilitate cleaning. Around the dosing plate, there is a baffle that very efficiently passes the powder expelled from the lower surface of the dosing plate through the duct. Reclaim and recycle while reducing dust on work surfaces.